FREE SHIPPING TO THE LOWER 48 STATES ON ORDERS OVER $50.00

*excludes Alaska, Hawaii & Puerto Rico

Current Performance Wiring - Standalone Gen 4 58x LSx Engine Wire Harness 2007+ E38 DBW (EV6 LS3 Injector 4.8L, 5.3L, 6.0L, 6.2L) 4L60E Transmission

$710.00
In stock
SKU
CPW-SKR-E346
- +

Standalone Gen 4 LSx Engine Wire Harness 2007+ E38 DBW (EV6 LS3 Injector 4.8L, 5.3L, 6.0L, 6.2L) 4L60E Transmission

Photos of products are sample images. Actual product may vary.

Designed to be a universal fit LSx engine harness, our Stocker Series harnesses come standard with a sealed fuse box, Techflex split braided loom, and heat shielding to protect areas of the harness that are typically near exhaust.

Easily add electric fans with our Sealed E-Fan Add-on Module

The CPW Stocker series harness contains all of the following connections:

  • ECM (Black and Gray Connections)
  • Crank position sensor (3 pin gray, rear passenger side behind starter. For 58x Crank reluctor)
  • Cam position/VVT (5 pin black, front of engine with adapter for 3 pin connection)
  • Knock sensors (2 pin cream colored plug, driver and passenger side of engine just above oil pan)
  • MAP sensor (3 pin gray plug w/ adapter to 3 pin black. Sensor mounts to intake in various locations depending on intake)
  • Engine coolant temperature (2 pin plug, front Driver’s side cylinder head)
  • Mass air flow (5 pin plug, front of engine. Sensor p/n 15865791 or equivalent)
  • Injectors (2 pin plugs, EV6 connection)
  • Coils (7 pin gray plug, between middle 2 injectors on each side of engine. Connects to factory coil sub-harness)
  • Throttle body (6 pin black plugs in to throttle body)
  • Electronic pedal (6 pin black out near ECM. For use with Corvette pedal p/n 19417903 or equivalent. Swap pins D & F, Brown & White/black, for truck pedal)
  • Oxygen sensors (5 pin trapezoid black. Uses sensor p/n 12581966 or equivalent. Routed out back side of engine)
  • Alternator (4 pin plug, 2 wires w/ adapter to 2 pin)
  • Oil Pressure (3 pin small round w/ adapter for larger style connection. Center back of engine behind intake)
  • Cylinder Shutoff, DOD/AFM (5 pin black Center back of engine behind intake)
  • Diagnostic link connector (16 pin black, intended to mount inside vehicle for ease of access)
  • Vehicle speed sensor (2 pin plug long enough to reach tail of transmission)
  • Optional – 4L60E, 4L80E Automatic transmission connector (TCM connection, black connector with blue cover near ECM and round gray plug out back of engine)
  • Optional – Input speed sensor (2 pin plug, included with 4L80e transmission option)
  • Optional – 6L80E Automatic transmission connector (Round black 16 pin connection out back of engine)

Bare input and output wires

  • 12V switched (Pink/Black, ignition power signal from vehicle ignition switch)
  • Power to Fuel Pump (Gray, 20A fused output from fuel pump relay pre-installed in sealed fuse box)
  • Tachometer (White, engine speed output from ECM)
  • Speedometer (Dk Green/White, calculated vehicle speed output from ECM)
  • Check Engine (Brown/White, ground signal from ECM to operate service engine light)
  • Fan 1 (Dark Green, control wire from ECM to operate primary electric fan relay)
  • Fan 2 (Dark Blue, control wire from ECM to operate secondary electric fan relay)
  • Optional – Brake Switch (Light Blue, connect to brake switch for TCC lockup control)
  • Optional – Tap shift (Purple, connect to resistor pack for tap shift control)

 

More Information

Bullet Point 1 Made in the USA with OEM connectors for the best possible connections
Bullet Point 2 Gen IV LS3 standalone harness
Bullet Point 3 This swap harness is specific for 2007+ Gen IV 58x engines with E38 ECU, EV6 Injectors and 4L60E
Bullet Point 4 Compatible with Automatic Transmissions
Bullet Point 5 Compatible with Drive by Wire Throttle Bodies
Weight 8.000000
ICT Manufacturer Current Performance
United States United States
Length Inches 15
Width Inches 15
Height Inches 3
Download .PDF for Vehicle No

WARNING - This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to www.P65Warnings.ca.gov

 

ALUMINUM: Most of the aluminum alloys used today contain some level of lead, usually less than .1%. Lead is known to the state of California to cause cancer and reproductive harm. Most aluminum alloys are physiologically inert in their solid form, and the lead is contained within, however user-generated dust and/or fumes may pose a hazard if inhaled or ingested. Heating beyond a certain temperature may also provide avenues for exposure.

 

STEEL (steel bolts):  Steel is an iron alloy with several metals including Nickel and Chromium. Both Nickel and Chromium are known to the State of California to cause cancer and reproductive harm, respectfully. This warning applies to stainless steels as well.